Diagram displays device, which is not connected to anything. The
situation appears when site separation prevents displaying the
device on the other end. To show connection to a device, click Show
Diagrams drill-down missing. Current diagrams offer vast amount of
information, which is not available through drill-downs. More
drill-down capabilities are planned for future releases.
Advanced Filter Visibility. When Advanced filter is applied, and
then collapsed via advanced filter button
it’s not clear that filter is being applied to the table, except for
the visible clear filter button.
Jumphost can be activated only from support console.
TACACS may be limited to the specific maximum number of simultaneous
authentication sessions, preventing discovery of all of the devices in the
network. If fewer than expected number of devices are discovered, decrease
bandwidth rate (like to 3Mb/s), increase SSH/TELNET session timeout (for
example to 30 seconds), and decrease the maximum number of simultaneous
sessions (like 40).
Inter-platform spanning-tree topology enumeration requires L2
discovery protocol to form a connection when
port_id.port_priority.port_id field separation boundary is in
inconsistent position between the two platforms.
Site separation - Changing “Firewall in site” and new
discovery/recalculation can change site names.
Snapshots (Release Candidate)
When Discovery is stopped mid way, and then Refresh is executed, the
refresh does not consider IPs with status “STOP” for the next
Resource check for sufficient RAM and HDD use a sliding window.
Creating a new snapshot immediately after previous one may result in
a “insufficient resources” failure. In such a case, verify resources
on the status page and retry in several minutes.
Visualization does not work properly in Internet Explorer. Use
Firefox or Chrome.
Switching site separation to RegEx can cause issues.
Duplicate IP detection
Anycast IP addresses are reported as duplicate addresses.